Taking Care Of Sacramento Contact Lenses

By Nancy Gardner


Contact lens should only be won following a prescription from your doctor. This also applies even if the purpose of wearing them is other than for visual correction. During eye examination, the optician will access your eyes health, myopia, hyperopia and astigmatism. Your visual acuity has to get assessed too before Sacramento contact lenses are prescribed.

In their insertion, the hands must be washed and dried thoroughly beforehand. The principal hand pointer finger is used to grasp the lens at the tip. The middle finger is utilized in pulling down the posterior eyelid.

The pointer finger of the less dominant hand is used in elevating the anterior eyelid. The lens is then slid gently onto the sclera while you are looking up. The fingers are then removed and the eyelids let go. Centering of lens is facilitated by closing the eyes for a moment. The same procedure is used when inserting the second lens.

When taking them out, again you start with hand washing and drying them thereafter. While gazing upwards, the lower lid is pulled downwards using the dominant hand middle finger. The pointer finger is then used to slide out the lenses by squeezing it between the finger and the thumb. Given the delicate nature of the lens and the sensitivity of the eye, this should be carried out with a lot of caution.

The disposable ones are thrown away after a single use. Using them eliminates the need for constant cleaning and storage. However, these processes are not as hard as they are made to sound. As long as you follow the instructions given by the optician, everything will just go smoothly. There are specially made solutions for rinsing, disinfecting, protein removal and conditioning the lenses.

For comfortable and healthy contact lens wear, they have to get cared for on a daily basis. The procedure involves placing commercial cleaner drops on each on the lenses sides and rubbing gently for about twenty seconds. This is followed by thorough rinsing for about five minutes with a rinsing solution prepared commercially

After the rinsing, they should be put inside a lens case and soaked using a cleansing solution for around 4 hours. The solution used for soaking should always be fresh and discarded immediately after use. After this, you can confidently put on lenses. If there is debris on the lenses surface, they can be done away with using a rinsing solution before being worn.

If they are not in use, they must be kept in specially made cases for safety purposes. They should never be soaked in a saline solution. This does not result to disinfection. The cases may remain closed for a period of thirty days if they are not in use. However, beyond this, they have to be cleaned and disinfected before insertion. The solutions used should be professionally prepared. Otherwise, using something else will not be effective in accomplishing the purpose. Also, the results will be compromised in case the solution is been reused. The case the lens are stored in should be changed on a monthly basis.




About the Author:



No comments:

Post a Comment